klipper-dgus/test
Kevin O'Connor 5d26c2a08e gcode_arcs: Add back in support for E moves in absolute extrude mode
This reverts commit 43fa41c1af.

The above commit disabled absolute extrude moves because it was
unclear if the code would work properly when an M221 extrude factor or
G92 offset was in use.  However, since the calculation is done
relative to the raw E position and is sent as a raw E position to
gcode.cmd_G1() these modes should not matter.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2020-06-04 15:25:17 -04:00
..
configs test: Add generic-simulavr.cfg to printers.test 2020-01-23 23:29:32 -05:00
klippy gcode_arcs: Add back in support for E moves in absolute extrude mode 2020-06-04 15:25:17 -04:00