mirror of https://github.com/Desuuuu/klipper.git
gcode_arcs: Add back in support for E moves in absolute extrude mode
This reverts commit 43fa41c1af
.
The above commit disabled absolute extrude moves because it was
unclear if the code would work properly when an M221 extrude factor or
G92 offset was in use. However, since the calculation is done
relative to the raw E position and is sent as a raw E position to
gcode.cmd_G1() these modes should not matter.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
parent
2a66286d1c
commit
5d26c2a08e
|
@ -38,20 +38,23 @@ class ArcSupport:
|
|||
if not asI and not asJ:
|
||||
raise gcmd.error("G2/G3 neither I nor J given")
|
||||
asE = gcmd.get_float("E", None)
|
||||
if asE is not None and gcodestatus['absolute_extrude']:
|
||||
raise gcmd.error("G2/G3 only supports relative extrude mode")
|
||||
asF = gcmd.get_float("F", None)
|
||||
clockwise = (gcmd.get_command() == 'G2')
|
||||
|
||||
# Build list of linear coordinates to move to
|
||||
coords = self.planArc(currentPos, [asX, asY, asZ], [asI, asJ],
|
||||
clockwise)
|
||||
e_per_move = e_base = 0.
|
||||
if asE is not None:
|
||||
if gcodestatus['absolute_extrude']:
|
||||
e_base = currentPos[3]
|
||||
e_per_move = (asE - e_base) / len(coords)
|
||||
|
||||
# Convert coords into G1 commands
|
||||
for coord in coords:
|
||||
g1_params = {'X': coord[0], 'Y': coord[1], 'Z': coord[2]}
|
||||
if asE is not None:
|
||||
g1_params['E'] = asE / len(coords)
|
||||
if e_per_move:
|
||||
g1_params['E'] = e_base + e_per_move
|
||||
if asF is not None:
|
||||
g1_params['F'] = asF
|
||||
g1_gcmd = self.gcode.create_gcode_command("G1", "G1", g1_params)
|
||||
|
|
|
@ -3,7 +3,6 @@ DICTIONARY atmega2560.dict
|
|||
CONFIG gcode_arcs.cfg
|
||||
|
||||
# Home and move in arcs
|
||||
M83
|
||||
G28
|
||||
G1 X20 Y20 Z20
|
||||
G2 X125 Y32 Z20 E1 I10.5 J10.5
|
||||
|
|
Loading…
Reference in New Issue