klipper-dgus/config/sample-probe-as-z-endstop.cfg

# This file provides example config file settings for use on a printer
# that uses a Z probe instead of a traditional Z endstop switch. This
# file is just a "snippet" of config sections - it must be added to a
# config file containing the configuration of the rest of the printer.

# Be sure to review and update this config with the appropriate pins
# and coordinates for your printer.

# See the "example.cfg" and "example-extras.cfg" files for a
# description of config parameters.

# Define a probe
[probe]
pin: ar30
z_offset: 2.345

# Example settings to add to stepper_z section
[stepper_z]
endstop_pin: probe:z_virtual_endstop
position_min: -2 # The Z carriage may need to travel below the Z=0
                 # homing point if the bed has a significant tilt.

# The homing_override section modifies the default G28 behavior
[homing_override]
set_position_z: 0
axes: z
gcode:
    G90
    ; G1 Z2 F600 ; Uncomment to blindly lift the Z 2mm at start
    G28 X0 Y0
    G1 X100 Y100 F3600
    G28 Z0

# Example bed_tilt config section
[bed_tilt]
points:
    100,100
    10,10
    10,100
    10,190
    100,10
    100,190
    190,10
    190,100
    190,190

# Example bed_mesh config section
[bed_mesh]
min_point: 20,20
max_point: 200,200
probe_count: 4,4