klipper-dgus/klippy
Kevin O'Connor c3efcd9c8d bus: Set all SPI CS pins high before first config_spi message
If an SPI device is shared among many devices, then all the device's
CS pins should be set high prior to setting up the clk pin.
(Otherwise, there's a chance a device could interpret the clk pin
setup as part of a transmission.)

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2019-01-04 22:26:34 -05:00
..
chelper winch: Add experimental support for cable winch kinematics 2018-12-24 11:38:59 -05:00
extras bus: Set all SPI CS pins high before first config_spi message 2019-01-04 22:26:34 -05:00
kinematics heater: take a gcode_id when setting up a heater (#1028) 2019-01-02 17:44:02 -05:00
clocksync.py clocksync: Simplify is_active() check 2018-05-31 18:20:30 -04:00
configfile.py configfile: Strip trailing comments 2018-10-16 11:45:20 -04:00
console.py console: Try to improve the description of the SUPPRESS command 2018-11-16 17:16:14 -05:00
gcode.py respond: An extra for sending messages to the printer host. (#1053) 2019-01-02 17:45:35 -05:00
heater.py heater: take a gcode_id when setting up a heater (#1028) 2019-01-02 17:44:02 -05:00
homing.py endstop_phase: Move endstop phase homing code to new "extras" module 2018-10-16 13:09:23 -04:00
klippy.py klippy: No need to return anything from _connect() method 2018-10-18 15:58:52 -04:00
mathutil.py delta_calibrate: Perform coordinate descent in a background process 2018-10-15 19:01:19 -04:00
mcu.py mcu: Allow set_stepper_kinematics() to set the kinematics back to None 2018-12-24 11:42:13 -05:00
msgproto.py msgproto: Add support for a get_constant_int() method 2018-05-28 10:43:40 -04:00
parsedump.py build: Request python2 for all directly executed python binaries 2017-06-27 20:26:02 -04:00
pins.py bus: Don't raise a "duplicate pin" warning on None pins 2019-01-02 17:37:39 -05:00
queuelogger.py klippy: Automatically clear rollover_info on each restart 2018-04-03 13:18:52 -04:00
reactor.py reactor: Add ability to register callbacks 2018-06-30 14:13:47 -04:00
serialhdl.py serialqueue: Limit message transmission to available receive buffer size 2018-05-28 11:12:30 -04:00
stepper.py endstop_phase: Move endstop phase homing code to new "extras" module 2018-10-16 13:09:23 -04:00
toolhead.py toolhead: Do not apply main printer accel/velocity to extrude only moves 2019-01-04 12:47:45 -05:00
util.py util: Fix versioning when gitdir is absent (#809) 2018-10-27 10:44:38 -04:00