Matt Baker f2fbe98454 bed_mesh: enable relative offset bed meshes (#1323) ... Adds parameter for bed meshes to be adjusted relative to a probed point during calibration. This allows the probe z offset to be ignored for probes that are not stable over time (for example, the thermal drift of inductive probes). An endstop other than the probe is then necessary to determine the bed-nozzle offset. Signed-off-by: Matt Baker <baker.matt.j@gmail.com>		2019-03-21 10:39:22 -04:00
..
chelper	serialqueue: Wrap code to 80 columns	2019-02-27 14:20:15 -05:00
extras	bed_mesh: enable relative offset bed meshes (#1323)	2019-03-21 10:39:22 -04:00
kinematics	gcode: Change respond_info() to log by default	2019-03-04 13:04:18 -05:00
clocksync.py	clocksync: Wrap code to 80 columns	2019-02-27 13:01:52 -05:00
configfile.py	configfile: Strip trailing comments	2018-10-16 11:45:20 -04:00
console.py	console: Wrap code to 80 columns	2019-02-27 13:00:30 -05:00
gcode.py	menu: Show current positions based on gcode positions (#1389)	2019-03-21 10:37:28 -04:00
heater.py	heater: Wrap code to 80 columns	2019-02-27 13:09:24 -05:00
homing.py	bltouch: Verify probe always deploys during a homing operation	2019-01-21 09:52:11 -05:00
klippy.py	klippy: Wrap code to 80 columns	2019-02-27 13:18:43 -05:00
mathutil.py	gcode: Change respond_info() to log by default	2019-03-04 13:04:18 -05:00
mcu.py	endstop: Use "pin_value" instead of "pin" when querying endstop state	2019-03-19 10:48:33 -04:00
msgproto.py	msgproto: Convert static strings to a more generic enumeration system	2019-03-17 19:38:18 -04:00
parsedump.py	build: Request python2 for all directly executed python binaries	2017-06-27 20:26:02 -04:00
pins.py	pins: Document support for '~' to enable pull-down resistors	2019-03-17 21:07:31 -04:00
queuelogger.py	klippy: Automatically clear rollover_info on each restart	2018-04-03 13:18:52 -04:00
reactor.py	reactor: support for delayed callbacks	2019-01-07 21:38:36 -05:00
serialhdl.py	msgproto: Convert static strings to a more generic enumeration system	2019-03-17 19:38:18 -04:00
stepper.py	endstop_phase: Move endstop phase homing code to new "extras" module	2018-10-16 13:09:23 -04:00
toolhead.py	gcode: Change respond_info() to log by default	2019-03-04 13:04:18 -05:00
util.py	util: Wrap code to 80 columns	2019-02-27 13:05:37 -05:00