mirror of https://github.com/Desuuuu/klipper.git
b22a81cd34
Added the pwm_cycle_time option for heater config sections. Defaults to previous value of 0.100 seconds, but may be reduced to shorter times at the expense of MCU workload and possible MOSFET heating, depending on controller design. Some printers that need bed PID to be enabled, notably the Felixprinters series, are known to benefit from shorter cycle times, as the default 10hz rate results in excessive voltage supply droop. While this option can be used on extruder heaters as well, there is not expected to be any particular benefit from doing so unless the extruder heater presents a particularly large load. Signed-off-by: Andy Silverman <andrewsi@outlook.com> Signed-off-by: Kevin O'Connor <kevin@koconnor.net> |
||
|---|---|---|
| .. | ||
| avrsim.cfg | ||
| example-corexy.cfg | ||
| example-delta.cfg | ||
| example-extras.cfg | ||
| example.cfg | ||
| generic-cramps.cfg | ||
| generic-melzi.cfg | ||
| generic-printrboard.cfg | ||
| generic-rambo.cfg | ||
| generic-ramps.cfg | ||
| generic-replicape.cfg | ||
| lulzbot-taz6-2017.cfg | ||
| makergear-m2-2012.cfg | ||