Many non-English speaking countries use a comma as a decimal separator for printed numbers. This can create some confusion in documentation and config files when not surrounded by contextual clues like parenthesis. Improve documentation by adding spaces to coordinates.
Signed-off-by: Paul McGowan <mental450@gmail.com>
This is useful when a saved bed mesh is used to ensure that the bed level
has not drifted too far from where it was when the mesh was created.
Signed-off-by: Johannes Stuettgen <johannes.stuettgen@gmail.com>
Any hardware change to the hotend or probe, change to the kinematics,
or change to the bed tilt is likely to invalidate the results of
PROBE_CALIBRATE. Try to warn the user of that.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The screws_tilt_adjust takes nozzle coordinates, but the goal is for
the Z probe to be above the screws.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The sample count and associated settings are no longer in the
screws_tilt_adjust config section - they are now in the probe config
section. Remove them from the guide.
Reported by @theopensourcerer.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Haxk20
Paul McGowan
Yifei Ding
Damien
Matthew Lloyd
Johannes Stuettgen
Kevin O'Connor
Rui Caridade