This is useful when a saved bed mesh is used to ensure that the bed level
has not drifted too far from where it was when the mesh was created.
Signed-off-by: Johannes Stuettgen <johannes.stuettgen@gmail.com>
Any hardware change to the hotend or probe, change to the kinematics,
or change to the bed tilt is likely to invalidate the results of
PROBE_CALIBRATE. Try to warn the user of that.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The screws_tilt_adjust takes nozzle coordinates, but the goal is for
the Z probe to be above the screws.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The sample count and associated settings are no longer in the
screws_tilt_adjust config section - they are now in the probe config
section. Remove them from the guide.
Reported by @theopensourcerer.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Damien
Matthew Lloyd
Johannes Stuettgen
Kevin O'Connor
Rui Caridade