diff --git a/config/generic-creality-v4.2.10.cfg b/config/generic-creality-v4.2.10.cfg
index e3be80c0..80535b61 100644
--- a/config/generic-creality-v4.2.10.cfg
+++ b/config/generic-creality-v4.2.10.cfg
@@ -2,13 +2,13 @@
 # use this config, during "make menuconfig" select the STM32F103 with
 # a "28KiB bootloader" and serial (on USART1 PA10/PA9) communication.
 
-# Flash this firmware by copying "out/klipper.bin" to a SD card and
 # If you prefer a direct serial connection, in "make menuconfig"
 # select "Enable extra low-level configuration options" and select
 # serial (on USART3 PB11/PB10), which is broken out on the 10 pin IDC
 # cable used for the LCD module as follows:
 # 3: Tx, 4: Rx, 9: GND, 10: VCC
 
+# Flash this firmware by copying "out/klipper.bin" to a SD card and
 # turning on the printer with the card inserted. The firmware
 # filename must end in ".bin" and must not match the last filename
 # that was flashed.
@@ -81,7 +81,6 @@ max_temp: 130
 
 [mcu]
 serial: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
-baud: 250000
 restart_method: command
 
 [printer]
diff --git a/config/printer-creality-cr30-2021.cfg b/config/printer-creality-cr30-2021.cfg
index 7d4f6c95..de946920 100644
--- a/config/printer-creality-cr30-2021.cfg
+++ b/config/printer-creality-cr30-2021.cfg
@@ -125,7 +125,6 @@ static_value: 0
 
 [mcu]
 serial: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
-baud: 250000
 restart_method: command
 
 [display]