From a698aef29bc252c0680111ca88754a676e94ee65 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Wed, 26 Sep 2018 19:43:44 -0400 Subject: [PATCH] config: Note probe activate/deactivate must not move the toolhead Signed-off-by: Kevin O'Connor --- config/example-extras.cfg | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 61a3d276..459a61aa 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -33,12 +33,14 @@ #activate_gcode: # A list of G-Code commands (one per line; subsequent lines # indented) to execute prior to each probe attempt. This may be -# useful if the probe needs to be activated in some way. The default -# is to not run any special G-Code commands on activation. +# useful if the probe needs to be activated in some way. Do not +# issue any commands here that move the toolhead (eg, G1). The +# default is to not run any special G-Code commands on activation. #deactivate_gcode: # A list of G-Code commands (one per line; subsequent lines -# indented) to execute after each probe attempt completes. The -# default is to not run any special G-Code commands on deactivation. +# indented) to execute after each probe attempt completes. Do not +# issue any commands here that move the toolhead. The default is to +# not run any special G-Code commands on deactivation. # Bed tilt compensation. One may define a [bed_tilt] config section to