mirror of https://github.com/Desuuuu/klipper.git
docs: document additions to BED_MESH_CALIBRATE
Signed-off-by: Eric Callahan <arksine.code@gmail.com>
This commit is contained in:
parent
7ba1a2a749
commit
3ac636b33e
|
@ -295,13 +295,30 @@ the coordinates listed under the "Probe" header to find the correct index.
|
|||
|
||||
### Calibration
|
||||
|
||||
`BED_MESH_CALIBRATE METHOD=[manual | automatic]`\
|
||||
`BED_MESH_CALIBRATE METHOD=[manual | automatic] [<probe_parameter>=<value>]
|
||||
[<mesh_parameter>=<value>]`\
|
||||
_Default Method: automatic if a probe is detected, otherwise manual_
|
||||
|
||||
Initiates the probing procedure for Bed Mesh Calibration. If `METHOD=manual`
|
||||
is selected then manual probing will occur. When switching between automatic
|
||||
and manual probing the generated mesh points will automatically be adjusted.
|
||||
|
||||
It is possible to specify mesh parameters to modify the probed area. The
|
||||
following parameters are available:
|
||||
- Rectangular beds (cartesian):
|
||||
- `MESH_MIN`
|
||||
- `MESH_MAX`
|
||||
- `PROBE_COUNT`
|
||||
- Round beds (delta):
|
||||
- `MESH_RADIUS`
|
||||
- `MESH_ORIGIN`
|
||||
- `ROUND_PROBE_COUNT`
|
||||
- All beds:
|
||||
- `RELATIVE_REFERNCE_INDEX`
|
||||
- `ALGORITHM`
|
||||
See the configuration documentation above for details on how each parameter
|
||||
applies to the mesh.
|
||||
|
||||
### Profiles
|
||||
|
||||
`BED_MESH_PROFILE SAVE=name LOAD=name REMOVE=name`
|
||||
|
@ -357,3 +374,9 @@ set, the generated probed points will be output to the terminal:
|
|||
The "Tool Adjusted" points refer to the nozzle location for each point, and
|
||||
the "Probe" points refer to the probe location. Note that when manually
|
||||
probing the "Probe" points will refer to both the tool and nozzle locations.
|
||||
|
||||
### Clear Mesh State
|
||||
|
||||
`BED_MESH_CLEAR`
|
||||
|
||||
This gcode may be used to clear the internal mesh state.
|
||||
|
|
|
@ -382,7 +382,8 @@ section is enabled:
|
|||
|
||||
The following commands are available when the "bed_mesh" config
|
||||
section is enabled:
|
||||
- `BED_MESH_CALIBRATE [METHOD=manual] [<probe_parameter>=<value>]`:
|
||||
- `BED_MESH_CALIBRATE [METHOD=manual] [<probe_parameter>=<value>]
|
||||
[<mesh_parameter>=<value>]`:
|
||||
This command probes the bed using generated points specified by the
|
||||
parameters in the config. After probing, a mesh is generated and
|
||||
z-movement is adjusted according to the mesh. See the PROBE command
|
||||
|
|
Loading…
Reference in New Issue