From 310cdf88ccdbc72283ce9ed7783f35a33198f9f1 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Sun, 18 Mar 2018 11:32:28 -0400 Subject: [PATCH] config: Remove tabs from printer-wanhao-duplicator-i3-v2.1-2017.cfg Remove tabs from example config file and replace with spaces. Signed-off-by: Kevin O'Connor --- ...printer-wanhao-duplicator-i3-v2.1-2017.cfg | 26 +++++++++---------- 1 file changed, 13 insertions(+), 13 deletions(-) diff --git a/config/printer-wanhao-duplicator-i3-v2.1-2017.cfg b/config/printer-wanhao-duplicator-i3-v2.1-2017.cfg index a3990bed..d1495afb 100644 --- a/config/printer-wanhao-duplicator-i3-v2.1-2017.cfg +++ b/config/printer-wanhao-duplicator-i3-v2.1-2017.cfg @@ -34,28 +34,28 @@ # # This is the inverse of "E steps" (extruder steps per mm) from the stock # Wanhao Repetier-based firmware. -# (See https://3dprinterwiki.info/extruder-steps/ ) +# (See https://3dprinterwiki.info/extruder-steps/ ) # -# For example, if your E-steps are set to 107.0 steps per mm, -# then step_distance should be (1 / 107.0) ~= .009346 +# For example, if your E-steps are set to 107.0 steps per mm, +# then step_distance should be (1 / 107.0) ~= .009346 # # * [extruder] > PID parameters (pid_Kp, pid_Ki, pid_Kd) # * [heater_bed] > PID parameters (pid_Kp, pid_Ki, pid_Kd) # # PID values from stock Wanhao firmware (Repetier) do not # translate directly to klipper. You will need to run klipper's -# PID autotune function for the extruder and bed. After getting the -# klipper firmware up and running, run the M303 autotune procedures -# by sending these commands via octoprint terminal (one per autotune): +# PID autotune function for the extruder and bed. After getting the +# klipper firmware up and running, run the M303 autotune procedures +# by sending these commands via octoprint terminal (one per autotune): # -# extruder: M303 E0 S -# heated bed: M303 E-1 S +# extruder: M303 E0 S +# heated bed: M303 E-1 S # -# After the autotune process completes, PID parameter results -# can be found in the Octoprint terminal tab (if you're quick) -# or in /tmp/klippy.log. +# After the autotune process completes, PID parameter results +# can be found in the Octoprint terminal tab (if you're quick) +# or in /tmp/klippy.log. # -# Enter the PID parameters into the appropriate sections of ~/printer.cfg . +# Enter the PID parameters into the appropriate sections of ~/printer.cfg . # # * [extruder] > max_temp # * [heater_bed] > max_temp @@ -68,7 +68,7 @@ # * [mcu] > serial # # Enter the USB serial port of the printer in /dev/serial/by-id/ format -# for best results. +# for best results. # # - Power cycle the Wanhao Duplicator i3 #