klipper-dgus/docs/Features.md

Klipper is an experimental 3d printer firmware. It has several
compelling features:

* High precision stepper movement. Klipper utilizes an application
  processor (such as a low-cost Raspberry Pi) when calculating printer
  movements. The application processor determines when to step each
  stepper motor, it compresses those events, transmits them to the
  micro-controller, and then the micro-controller executes each event
  at the requested time.  Each stepper event is scheduled with a
  precision of 25 micro-seconds or better. The software does not use
  kinematic estimations (such as the Bresenham algorithm) - instead it
  calculates precise step times based on the physics of acceleration
  and the physics of the machine kinematics. More precise stepper
  movement translates to quieter and more stable printer operation.

* Best in class performance. Klipper is able to achieve high stepping
  rates on both new and old micro-controllers. Even an old 8bit AVR
  micro-controller can obtain rates over 175K steps per second. On
  more recent ARM micro-controllers, rates over 450K steps per second
  are possible. Higher stepper rates enable higher print
  velocities. The stepper event timing remains precise even at high
  speeds which improves overall stability.

* Configuration via simple config file. There's no need to reflash the
  micro-controller to change a setting. All of Klipper's configuration
  is stored in a standard config file which can be easily edited. This
  makes it easier to setup and maintain the hardware.

* Portable code. Klipper works on both ARM and AVR
  micro-controllers. Existing "reprap" style printers can run Klipper
  without hardware modification - just add a Raspberry Pi. Klipper's
  internal code layout makes it easier to support other
  micro-controller architectures as well.

* Simpler code. Klipper uses a very high level language (Python) for
  most code. The kinematics algorithms, the gcode parsing, the heating
  and thermistor algorithms, etc. are all written in Python. This
  makes it easier to develop new functionality.

* Advanced features. Klipper implements the "pressure advance"
  algorithm for extruders. When properly tuned, pressure advance
  reduces extruder ooze. Klipper also implements a novel "stepper
  phase endstop" algorithm that can dramatically improve the accuracy
  of typical endstop switches. When properly tuned it can improve a
  print's first layer bed adhesion.

To get started with Klipper, read the [installation](Installation.md)
guide.

Common features supported by Klipper
====================================

Klipper supports many standard 3d printer features:

* Works with Octoprint. This allows the printer to be controlled using
  a regular web-browser. The same Raspberry Pi that runs Klipper can
  also run Octoprint.

* Standard G-Code support. Common g-code commands that are produced by
  typical "slicers" are supported. One may continue to use Slic3r,
  Cura, etc. with Klipper.

* Constant speed acceleration support. All printer moves will
  gradually accelerate from standstill to cruising speed and then
  decelerate back to a standstill.

* "Lookahead" support. The incoming stream of G-Code movement commands
  are queued and analyzed - the acceleration between movements in a
  similar direction will be optimized to reduce print stalls and
  improve overall print time.

* Support for both delta printers and cartesian style printers.

Step Benchmarks
===============

Below are the results of stepper performance tests. The numbers shown
represent total number of steps per second on the micro-controller.

| Micro-controller  | 1 stepper active | 3 steppers active |
| ----------------- | ---------------- | ----------------- |
| 20Mhz AVR         | 177K             | 117K              |
| 16Mhz AVR         | 140K             | 93K               |
| Arduino Due (ARM) | 462K             | 406K              |